Information on application and glue preparation.

Information on application and glue preparation.

The surface to be applied must be smooth.
Air circulation should be prevented by closing the doors and windows in your room.
In the process of preparing the glue, the powder is prepared by mixing it with water as if it were soup, until the glue had a thick consistency. (Otherwise, clumping occurs.) The prepared glue is allowed to stand for 3-4 minutes before application.
It is applied by brush or roller to the back of the paper and pasted to the wall. (For non-woven papers, glue can be applied to the wall.)
When applying the glue, it should be applied in such a way that there is no dry area, especially the edge areas.
When gluing 3D wallpaper pieces to the wall, one piece must be overlapped by 10 mm on top of the other piece.
If air bubbles remain after gluing, use a damp cloth or squeegee to flatten out the air.


Applying a poster or wallpaper is not as difficult as it seems.

Let's start by preparing the wall first. You can remove any paint residues and roughness with a spatula and fill the gaps with plaster. The cleaner and smoother the wall, the better the result.

Let's check our wallpaper - our poster. If we have given the correct measure, let's review if there is any error, check the fit of the parts and determine which part to start with.

We'll prepare the glue in a small bucket. We will mix the glue that comes with the amount of your paper with water according to the amount. It can be bonded up to 15 m2 with 5 liters of water.

We will put the glue on the back of the paper with a glue brush and let it stand for five to ten minutes.

After placing the part ready to be bonded properly, we can continue to the second one.